Hp Resume Button

Reconnect the power cord to the rear of the printer.

Hp resume button. If these steps resolved the issue and the test page prints there is no need to continue troubleshooting. The Resume light continues to blink after the paper jam is cleared. Stops a print copy or scan job.

3 Start Copy Black. Load paper in the paper tray and press the RESUME button. If the Wi-Fi Direct icon is blinking in sync with the white blinking Information light the Wi-Fi Protected Setup WPS push button mode is in progress.

Check for and remove any paper stuck in the paper In tray. Starts a black-and-white copy job. The light indicates that the printer is in a warning or error state.

As you can see from the picture below Power Resume button and Cartridge indicators are blinking. Instructs the HP All-in-One to continue after a problem is solved. Close the cartridge access door.

Press the Power button to turn on the printer. To turn Wi-Fi Direct on or off press and hold the Wireless button and the Resume button together for three seconds. If more than one sheet is stuck in the printer remove the paper one sheet at a time by.

If a print cartridge is low on ink consider replacing the print cartridge. When the print job is complete print a self-test report. Make sure the ink cartridge door is completely closed.